A striking dimensional finishing treatment, board and batten, is enjoying renewed popularity, with homeowners installing it both on the exterior and indoors. Historically a staple of Arts and Crafts architecture, board and batten originated as a form of house siding. The term “batten” refers to the strip of molding placed across the joint between boards. The resulting look boasts an attractive geometry: strong vertical lines balanced by a sense of texture across the horizontal.
As an exterior cladding, board and batten manages to impart a rustic, handmade quality even to new homes built in unmistakably contemporary styles. Within the home, board and batten commonly appears in mudrooms and hallways, bedrooms and dining areas, adding charm to otherwise bland expanses of drywall or plaster. Many traditional designs for non-permanent elements of the home-shutters, for example, or cabinet doors-also feature board-and-batten construction.
For the average do-it-yourselfer, installing board and batten lies well within reach, especially since home centers and hardware stores often sell pre-measured kits that make it a breeze. If you are planning a project either on the exterior or interior, here are a few hard-earned tips to help you achieve a professional-level result:
Exterior Installation Tips:
• Before you begin the work of installation, paint or stain the boards and battens, and don't forget to apply a sealer, protecting the wood from the weather.
• Start by cutting the boards, typically to width between one and four feet. Leave a 1/4- or 1/2-inch gap between the boards to allow for seasonal expansion.
• Center the one- or two-inch-wide battens over the joints between the boards. Nail through the battens so that the fasteners drive into the expansion gaps.
• Buy or build enough battens to use as trim pieces that finish off the top and bottom edges of your installation, as well as its sides or corners.
Interior Installation Tips:
• Depending on height, interior installations typically run between baseboard and chair or plate railing.
• Paint or stain the board and battens prior to installation just as you would do on the home exterior.
• A simple approach is to use plywood panel boards, roughly four feet wide by four- or six-feet tall.
• In the course of installing the boards, always retain a 1/4- or 1/2-inch expansion gap between them.
• Position one-by-two-inch or one-by-one-inch battens over the expansion gap between the boards.
• Nail through the center of the battens, so the fasteners drive between the boards and into the wall.
• Remember that any extra pieces of batten may be reused as molding around windows or door frames.
• If you prefer not to work with plywood, other cost-friendly materials include MDF and composite.
Board-and-batten styling imparts depth and texture to both exteriors and interiors, lending a sophisticated yet unpretentious air to virtually any home, whether it's a recent construction or has been around 100 years.